Subscribe via RSS Feed

May/June 2001

Large gen-sets for emergency systems

Emergency Electrical Systems Installations and Inspections

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

The installation and inspection of an emergency electrical system are critical elements regarding the protection of persons set forth in Section 90-1 of the National Electrical Code. Requirements for the emergency electrical circuits and emergency system are more restrictive than the rules for normal circuits and systems in chapters 1 through 4 of the Code. [...]

1 Star2 Stars3 Stars4 Stars5 Stars (2 votes, average: 4.00 out of 5)

Electricity Kills

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

The recent tragic and unnecessary death of yet another one of our children at play can not be acceptable to any concerned person, local elected official, or Florida legislator. Touching a light pole should not cause anyone’s death. We have witnessed too many deaths due apparently to faulty electrical work. State Representative Carlos Lacasa (R-Miami) [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Test Your Ground Fault Circuit Interrupter

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

Most homes built since the 1970s have a GFCI in their kitchen and bathrooms. GFCIs appear similar to standard electrical receptacles, but also have “test” and “reset” buttons. An estimated 400 million ground fault circuit interrupters (GFCIs) have been installed across the country. Their built-in test buttons should be used every month and after electrical [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

If I were a Manufactured Home, what Code Would I Use?

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

If you answered the National Electrical Code, you would be partially correct. Manufactured housing has its own set of construction standards that are found in 24 CFR Part 3280. This came into being in response to the National Manufactured Construction and Safety Standards Act of 1974 (42 U.S.C. 5403). These original rules were, for the [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Integrating NFPA Electrical Codes and Standards

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

Recently the National Fire Protection Association announced that their board of directors had taken a historic step in voting unanimously to pursue the development of NFPA 5000, NFPA Building Code. What makes this standard different from other building codes is that NFPA 5000 will be the first building code to be developed using the ANSI [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

NEIS: Enforcement Tools for Code Officials

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

Since 1997, the National Electrical Contractors Association (NECA) has been publishing a series of National Electrical Installation Standards™. There are currently eleven NEIS™ in print (see sidebar). Other documents in progress include installation standards on panelboards, busways, transformers, motors, wiring devices, hazardous (classified) locations, industrial heat tracing, telecommunications, and temporary power systems for construction sites. [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Photo 1. A case where the power cable entry point and termination is below the vent for the fuse

The NEC and Installations Over 600 Volts

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

The March/April issue of the IAEI News had an article on high voltage Equipment that discussed the new areas of application. The article discussed how these systems have evolved into some non-traditional areas along with some of the safety concerns for those working around this equipment. Codes and standards were discussed in general along with [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Photo 1. U-guard

Who Really Knows What It Means?

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

I have been working with and searching all aspects of the National Electrical Safety Code (NESC®) for almost 30 years. I refer to the book at least twice a day. Engineering, construction, claims and legal personnel in my company call or e-mail me regularly to ask questions about the NESC. Five years ago, I thought [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Photo 1. Equipment required to be properly rated for the load served

Rule 8-104 Maximum Equipment Loading

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

Rule 8-104 of the Canadian Electrical Code prescribes maximum permissible operating loads for electrical equipment, and maximum loads that may be carried by service, feeder and branch circuit wiring. This article looks into the requirements and limitations this rule imposes on the application of electrical equipment and wiring. Rule 8-104(1) gives us some important information [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Prefabricated Buildings are Categorized and Given One Classification Mark

[ 0 ] By  |  May 15, 2001  |  IAEI May-June 2001

Question: “Recommended” Occasionally the word “recommended” appears in manufacturers’ installation instructions. For example, “it is recommended that this product be used on a separate branch circuit.” Does the installer need to follow manufacturers’ “recommendations” to comply with Section 110-3(b) of the National Electrical Code (NEC)?

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Bad Behavior has blocked 2540 access attempts in the last 7 days.