Subscribe via RSS Feed

September/October 2001

Photo 15. I thought my fellow wood workers would enjoy the skill of the trim carpenter who scribed and coped this crown molding to the heat detector

Electrical Inspector’s Notes to Fire Alarm System

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

The National Electrical Code1 (NEC) and the National Fire Alarm Code2 (NFPA 72) have an interwoven relationship that is paramount to the proper operation of fire alarm systems. In the same way, the electrical inspector and the fire alarm inspector have common goals. This article will develop and build on the last issue’s article, “The [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Figure 1. Conductor overcurrent protection

Overcurrent Protection for Conductors

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

Requirements for overcurrent protection for conductors are found in Article 240, Overcurrent Protection, which is found in chapter two, Wiring and Protection, of the NEC. Electrical conductors are required to be protected against overcurrent in accordance with their ampacity ratings that are specified in Section 310-15. Chapter three covers wiring methods, and the conductors installed [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Grounding and Bonding Sensitive Electronic Equipment

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

No doubt everyone has experienced the frustration of a PC computer crash, lockup or unreliable data. Their cause is often due to voltage noise, formally defined as “unwanted disturbances imposed upon a useful signal to obscure its information content.” Transient power system voltages and high frequency leakage currents can result in such failures and other [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Connecting Heat-Producing Electrical Equipment

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

The Canadian Electrical Code provides us with rules for connections to heat-producing electrical equipment such as lighting, motors and continuously loaded equipment. Here the code has some special requirements, including minimum wiring insulation temperature ratings, reduced conductor ampacities and minimum spacings to ensure that unwanted heat is dissipated and will cause no harm to associated [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Photo 1. Armor cutting tool

MC Cable Installations

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

Type Metal Clad Cable (MC) is being installed in virtually every type of building under construction today including stadiums, schools, multi-family housing, hotels, commercial retail and office, industrial plants and warehouses along with many other facilities. This article addresses the interlocked armor Type MC cable with conductors No. 8 CU and No. 6 AL and [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

What’s Coming in 2002?

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

The National Electrical Safety Code (NESC) is now on a five- year revision cycle. The 2002 edition will be published on August 1, 2001, and “shall become effective no later than 180 days following its publication date” (Rule 016). There are a lot of changes. Over the next few IAEI News issues, I will try [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Cooking Fires

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

A report released by National Fire Protection Association (NFPA), indicates that fire deaths in 1998 due to cooking equipment rose 45 percent from the previous year, but that over all, the number of home cooking fires decreased by 8 percent to the lowest level in the nineteen years of the study. Cooking equipment fires remained [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

The 2002 National Electrical Code

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

Work on the 2002 National Electrical Code has been completed. Those using the NEC will find a significant difference in the new edition. It is likely to take some adjustments to become fully familiar with the new Code. Considerable effort has been made to make the new 2002 NEC more user friendly. It is the [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Figure 1. 110.15 High-Leg Marking

Preparing for the New Code

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

The 2002 National Electrical Code brings changes to the industry. Adopting provisions to keep up with advancing technology and recognizing that many existing safety rules have to be modified to address specific situations require reexamination of existing Code rules on a regular basis. The Code development process needs the participation of experts in the field [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Figure 1. AFCIs

Arc-Fault Circuit Interrupters

[ 0 ] By  |  September 12, 2001  |  IAEI September-October 2001

It is not often that a new safety device is introduced to protect individuals from the dangers that may be present in residential occupancies. Smoke alarms, carbon monoxide detectors, and ground-fault circuit interrupters are recognized as essential life saving devices. In 2002, the National Electrical Code (NEC) will require a new electrical safety device, the [...]

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)

Bad Behavior has blocked 2540 access attempts in the last 7 days.